How to install three-roll brake reasonably

In the communication with the customer to determine the plan, the width and length of the site, to determine how many machines can be installed, whether to choose vertical three-roll gate or bridge three-roll gate, vertical three-roll gate external dimension: 420x330x980(mm), bridge three-roll gate external dimension: 1200x280x1000(mm), the size of three-roller brake rod to chassis 510mm, namely, the floor area of vertical three-roller brake: 420X (330+510), bridge three roller brake covers an area of 1200x(280+510), in determining the selection of the consideration of the brake and brake bar gap, each three roller brake covers an area, location, how to wire (is to go open line or go dark line), the plan is set, the target is set, waiting for three roller brake to the scene. < / p > < p > according to previous plan, a clear three roll gate size installation, completes the embedded pipe, brake and brake machine for 50-100 - mm clearance between, can open the cover to prevent adjusting machine, maintenance and so on, must not leave gaps, brake and brake machine embedded between 2 pieces of plastic pipe 6-8 points, a piece of rubber hose the power cord (high voltage), Walk signal another hose (elv), not to leave the power cord and signal lines and a rubber hose, this will affect the communication effect, embedded pipe to reveal the ground 30 to 40 mm high, walk line at the bottom of the vertical three-roller brake should be in the middle of the machine, bridge type three roll brake should be on both sides as well, because at the bottom of the middle bridge type three roll gate is closed).