Parking brake common faults or the corresponding solution
2022-08-04 00:00:00
when the coil is not firmly fixed to the ground, the cars on the road of the ground vibration caused by the deformation will lead to coil and change the initial inductance of the ground, this sensor will be reset to normal work.The solution is to combine melted asphalt and fixed.
2, in position control magnet move a
in place up and down all use CiMin hall element, if the rectangular magnet and reducer wafer with CAM position change, caused by inaccurate in place.Adjust its accurate, do not turn the car boot can solve problem.
3, turn the arm loose screw
if the screw loose, will cause the brake lever lever and inaccurate and stop shaking is larger, the bolt hang tight, tighten up the nut.
4, power-off protection switch power
when the control part of the machine failure occurs, the automatic protection device will automatically work of the machine.At this point the brake lever stops in the tilted position, main power disconnected, the machine doesn’t work.At this time, open the door to the machine, the belt clockwise to the upper position, can restore the position, if you try to many times can restore the original state, you will need to check whether hall element and circuit board failure.