Your license plate recognition system has to have done maintenance gate?

2022-08-20 00:00:00

Many customers at the time of license plate recognition system is concerned about control system, which is often neglected the control equipment: brake, actually the brake occupies a very important position in the whole system, the normal operation of the system, so to speak is wholly dependent on the normal brake, once the brake can’t run, system basically is paralyzed, so how to ensure the normal operation of the license plate recognition system, need management attaches great importance to the parking lot.

in general, the brake if you can’t work normally, the license plate recognition system will happen the following problems:

1, the identification of license plate brake after don’t lift rod.
2, after the car brake lever.
3, abnormal rod process, do not want to be left in place.
4, brake lever can’t litres in place.
is the main reason of the failure:

1, vehicle detector signal was detected, so car not stem.
2, tao brake don’t lift rod, may be a way of brake is a fault in the detector.
3. The gate hoist does not reach the designated position, may be a way limit or balance of the brake spring is not normal.

so for the brake in license plate recognition system, we need to do the maintenance work exactly?

first of all, the brake often do need clean, ensure the brake of the brake lever surface finish.For the brake of the brake lever to every three months for a lubricant to critical rotational parts replacement, to insure the normal way brake lubrication.Check the balance spring after run 30000 times, and make balance adjustments in a timely manner.Every 6 months, please professional check is easy to wear, and timely replacement of wear parts.

second, if found in the course of using the brake before the small fault, to check once a month whether brake brake lever component showed signs of loosening and whether there is a loss, if found to deal with immediately, avoid even the appearance of hurt or hurt the car.

the third, want to look at the gate of the remote control performance is normal, the brake of the remote control battery life is usually one year, pay attention to replace the battery, do not be affected with damp be affected with damp, bang, impact.Remote control distance is too short, please check whether the host installation location covered with metal or adequacy of the battery.

any items of the correct use and maintenance can prolong the service life of it in time, and such is the brake, although parking brake of reduced the human, but to be on the safe side, still need to arrange personnel inspection maintenance on a regular basis.