Intelligent parking lot, brake troubleshooting
2023-09-24 00:00:00
processing methods: fell lever signal to a few times more, make brake fall in place.Limit the light, and then give a few times, elevating signal to limit the light, rod in place.Reciprocating a back and forth, the brake would have a normal
fault 2: the brake up reach the designated position, after a few seconds will automatically fall rod.
the solution: whether to feeling affected, pull the car inspection.See if adjust delay fall rod dial the code switch moved. (dial the code switch in the main board on the right side of the central, 2011 before the brake not the dial the code switch.)Dial the code switch is regulating rod falling delay 1, 2, 1, 2 are all oFF is not automatically fall bar, is automatically released 3, 3 is On automatic release, brake to sign at this time, will not fall rod, if above conditions are ruled out, there may be a motherboard, the motherboard is a problem with the main control chip,
fault 3: brake signal, to fall does not reach the designated position, once again give the signal, and no action.
the solution: look at the motherboard regulate brake type dial the code switch is correct, 6 seconds in the way of brake motor, dial the code switch to dial to 6, to other location is not enough,
fault 4: brake signal, to motor didn’t move.
the solution: check whether active crank arm cushion the shock flattening, stuck cause motor, motor card died, with a small screwdriver rotate at the bottom of the motor shaft, from active crank arm damping pads, and in this case is stop not limited to live, (2) look at startup capacitor is no good, or capacitance has been aging, appearance has transform!
fault 5: remote control don’t respond, open the mainboard buzzer rang.Drive-by-wire control.
the solution: treatment method to check the remote control.Check the mainboard remote control near the plug of three 9013 whether there is a triode, such as bad, replacing 9013 triode, the triode is common, general electronic market are sold,
fault six: the brake can not rise.Pull the limiter, litre fall is normal.Stop light long on up.
the solution: check whether low limit block slice of loose, if limiter failure
fault 7: brake clutch of legal: some clutch on the customer or not.
the best method is: half a signal to the motor, motor rotation stop (motor rotation position judgment: when active crank arm and the connecting rod overlap is in place.Active crank arm and the connecting rod into a straight line, is to fall in place) by hand to press the brake lever, and turn the clutch handle, this clutch is the easiest.Because the brake and clutch, vertical or horizontal position, due to the effect of damping pads, clutch and sometimes does not reach the designated position!
fault 8: the brake spring tension adjustment if you when installing the brake.
as long as the brake lever installed after the brake can rise, can drop feel spring tension is appropriate?The brake spring tension.Directly affect the brake of mechanical transmission and the stability of the main components.Tension is too large or too small, mechanical parts wear serious, element load is too large, the brake after the adjustment of the spring tension, brake lever installed later.Disconnect the clutch, hold rod with two hands to press brake lever that part of the (white) turn the brake lever, soak up the size of the force, when do you think can put the brake lever up and down turn force is small.At this time of the spring tension can already, and brake lever in the area of 30 to 60 degrees, can stop at any position.This is the best state.Generally the bad state of adjustment, but as long as the rotation, with the hand you the very light is the brake lever is installed in place.Finally opened the cover, the way brake automatically turn in place, the up limit down limit if damping rubber gasket stress.Let damping rubber gasket stress can play a buffer action, reduce and the inertia of the brake lever brake driving part damage.