Parking Spaces, feeling how coil installation?

2023-10-03 00:00:00

ground sense coil as an important part of the parking lot system, its operation affects the normal parking lot, the proper operation of the brake, so how to install sense coil is the specification?Below is our ground sense coil installation drawing.



we can see from the table, the feeling of width at the center of the brake lever below, this is must pay attention to, the coil from the gate edge distance of 500 mm.Will be cut into a lane ground (width * length) 1000 x2000 square groove, groove width 8-10 mm, 30-50 mm groove depth, inclination Angle of 60 degrees, corner be polished smooth.Then to sense a circle in the coil, and attention to compaction, between them within the coil don’t have a joint, the coil in the six to eight layer, don’t put more nor less.Because the coil number of turns affects the induction strength, if the number of turns in the coil, the more the greater the input impedance, are likely to cause open circuit, on the contrary, if too little number of turns, impedance is small, can cause a short circuit.Put away after the coil, we want to use dry cement seal.

after installation of ground sense coil, we want to test, in the sense of red light flashing, we use a piece of iron plate on the coil top, when the red light bright long removing iron, if brake automatically whereabouts with a successful installation.