Some requirements of parking equipment installation wiring

2023-10-28 00:00:00

under the power supply need to be aware of is this place, in order to make the parking system normal operation, reduce the fault, better give play to the role of management, the correct installation wiring is necessary, must be in accordance with the standard to install, here we will read one at a time.

parking equipment power supply system must be stable, so we must assure enough power when choosing installing power, it is best to use linear power supply, in order to avoid interference and transmission loss at the same time, should be close to the electrical equipment.

this is the place where the power need to pay attention to, the following us about wire, parking systems need to use the power cord, communication lines, signal lines.The power cord for wire diameter thick, adopt more strands of wire.

the intelligent parking lot system wiring installation note: signal and communication lines using shielding five kind of twisted pair.485 bus must use twisted pair line connection A +, A minus.4 * 0.5 wire when the choose and buy recommended four core shielded wire.The wiring should pay attention to the following:

& bull;Shielding wire never used as a 0 v voltage connecting cables (power supply)
& bull;Each shielding grounding loop can only have one side
& bull;When blocking circuit is not grounded in shielded wire can be connected to the network another loop.
& bull;Each module of signal ground must be connected together.
& bull;If the line with a breakpoint, need to use breakpoints on the soldering iron welding and disposal of the insulation.
& bull;Don’t put together network cable and the ac power

above is parking system installation wiring requirements, hope everybody can strictly regulate installation, finally thank you for reading.