Different occasions should how to install different channel brake?
2022-05-01 00:00:00
smart channel brake is roughly divided into three categories: wing brake, three roller brake and brake.Is a kind of non-contact intelligent wing gate channel detection and control of intelligent channel management equipment, adopted the latest electromechanical integration control and drive technology.Multiple sets of sensors through the glass door wings to achieve control of the entrances and exits, authorized legal personnel can not subject to any block passed without a single inspection, refused to unauthorized access, provide high quality gateway control.Three rod brake machine is economic in intelligent channel, the following can power, less occupied channel and low equipment installation environment requirements.And DRTD6306 is we elaborate a delicate appearance, reasonable design, safety, mechanical and electrical integration of the counterterrorism box-type three rod brake wit can set brake is economic channel management equipment, following ability, structure the most compact equipment.DRTD6607 series is a streamlined appearance, reasonable design of mechanical and electrical integration of half tall intelligent brake.Intelligent pendulum brake is a kind of non-contact channel detection and control of intelligent channel management equipment, adopted the latest electromechanical integration control and drive technology, multiple sensor control through the glass doors of inward and outward, the use of the equipment with entrance guard controller, authorized legal personnel can pass without any obstacles, without a single inspection, refused to unauthorized access, thus provides the high quality of gateway control.
three roll brake is mainly suitable for traffic was relatively more occasions, three roll up to a maximum of 550 mm, the channel width of brake so three roll brake is only suitable for people, not suitable for motor vehicles, three roll gate appearance is monotonous, but its usefulness can say two relative to other, brake machine, three roller brake performance is the boss.Of course wing brake and brake is also good.Second wing brake mainly used in some high to the requirement of appearance, some high-end occasions, wing brake should not be used as a single, must be composed of two or more than two channels, the channel made up of two sets of wings gate is 550 mm, generally also can only, if in a wheelchair or baggage can also be used in addition a long telescopic soft brake, like to lyzjc gate pass personnel can push the wheelchair and big luggage, wing brake because of its convenience and fashion are sought after by the masses of customers.The price in three relatively neutral, because its price relative to three roller gates to double.Pendulum is brake, moreover brake is mainly used in some area or factory to anybody and non-motor vehicles, and the advantage of the swing gate is that its channel width is more wide, the biggest can reach 1800 mm, very suitable for small area or do the narrow place at factory gate, in order to save place and traffic safety, a doorway into the channel and non-motor vehicles, motor vehicles put brake relative to three roller gates and wing brake you feel pendulum brake is the most likely place for the community or factory, but otherwise the pendulum brake for the space of the swing arm is larger, so the run time relative to the other two relatively slowly, the repair rate and the three roll brake brake wing relative swing gate will be higher.(http://www.nthuanlicn)