The parking lot, charging machine installation specification
2022-07-05 00:00:00
parking charging machine installation is not complicated, there are mainly two parts, one is the case of fixed and wiring.
a fixed and charging machine
installation must assure the stable of the machine.Here we want to according to the actual circumstances of the site environment, put the case to the location of the installation, determine the correct after the door is opened, completes the screw holes with a pencil in a fixed installation position of tag, tag and remove the charging machine, the drill bit with Ф 14 in the fixed screw, reoccupy Ф 12 expansion screws gate, to note here mount gasket and reed mat, fixed charge machine.The final charge machine for cleaning, use cotton cloth wipe off the equipment, charging machine fixed installation is complete.
2, charging machine wiring
the case after fixation, the next step is to wiring, wiring according to the wiring diagram, there is not much said, but said some of the other details.
the case inside logo to be clear, if not clear, the need to identify;Measuring the length of line
’to set aside 1 m margin line;
the first set of on-line nose line pressure is good, again according to the wiring diagram from the actuators to a chassis terminal;
the final inspection and case port connection is correct and terminals are tight;
after these two steps, charging machine installation is complete, in order to make the machine stability and lightning protection, however, there are two points to note: 1. The process of wiring, be sure to separate the power cord and signal lines such as the line of control, communication laid, set of feeding tube.
2. In terms of lightning protection, the grounding end of the charging machine and exposed to the power supply must be good, communication line shield.