How to deal with the tathagata gate parking system common fault?

Product is now highly intelligent parking lot system and brake parking system is the core of electromechanical integration equipment, undertaker in the parking lot control vehicle in and out of the lift of the action, ensure the normal operation of the parking lot.So now that is electrical and mechanical equipment, always have some trouble, the following summarizes the customers in the use of common faults in the way brake and treatment method.

a brake normal whereabouts bar above or below the level

if the rod is higher than the way brake is a horizontal position, check the lower limit of a falling pole control switch is loose, loose will limit a screw;The brake rail shorten and folding, can adjust tension spring by fine-tuning a screw length;Will the gate to debug to horizontal position, tighten the screw.Below the horizontal position, check the limit switch screw loose, look at the rail have no heavy waste load and brake motor worm gear wear self-locking performance is poor, limit function failure, clean up the railing, adjust the screw, replace the turbine worm, to debug the correct position, tighten the screw.

2 brake signal reception, not completed normal action

is often encounter this situation, the brake after receive signals, or action, or actions cannot be reset, and give a signal is a lower the abnormal action of brake lifting movement.Know the brake lever, back and forth several times, elevating signal to reset the way brake machine, check the gate after the dial the code switch, dial the code switch is reset, tuned into a state of normal use;Check the status of the motor is stuck, and maintenance or replacement of the motor;According to the way brake electrical drawings, check electrical electronics, replacement and electric circuit boards, capacitors, damaged wires.